Product ID:SATINHIDE LATES NEUTRAL BASE, 88-587
MSDS Date:11/20/1989
FSC:8010
NIIN:00N027278
MSDS Number: BNLSF

PPG INDUSTRIES INC

260 KAPPA DR
PITTSBURGH, PA 15238
US

Emergency Phone: 304-843-1300

Info Phone: 412-963-5822

Cage: 47695

PPG INDUSTRIES INC

PITTSBURGH, PA 15272 US

Telephone: 1-800-245-2974 (CAL HYPO)

Cage: 47695

EXPECTED TO GENERATE EXCESSIVE AMOUNTS OF RESPIRABLE

RTECS: 9999999ZZ

SHEET INFO AVAILABLE. *INGEST *EXCESSIVE

RTECS: 9999999ZZ

OR BREATHING DIFFICULTIES.

RTECS: 9999999ZZ

LIMITS, THE LEL BELOW THE STATED LIMIT, AND TO REMOVE

RTECS: 9999999ZZ

COATED WITH THIS PROD.

RTECS: 9999999ZZ

RUBBER, NITRILE RUBBERBUTYL RUBBER OR LATEX

RTECS: 9999999ZZ

FREE FALL OF LIQUIDS IN EXCESS OF A FEW INCHES.

RTECS: 9999999ZZ

CALCIUM CARBONATE

CAS: 471-34-1

RTECS: FF9335000

Fraction By Weight: 2-5%

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 10 MG/M3 TDUST

SILICA, CRYSTALLINE - QUARTZ; (MICROCRYSTALLINE SILICA

CAS: 14808-60-7

RTECS: VV7330000

Fraction By Weight: 2-5%

OSHA PEL SEE TABLE Z3

ACGIH TLV: 0.1 MG/M3 RDUST;9293

WATER; (DEIONIZED WATER)

CAS: 7732-18-5

RTECS: ZC0110000

Fraction By Weight: 50-55%

FILM FORMERS, RESINS, AND ADDITIVES

Fraction By Weight: 30-35%

IN LAB ANIMALS. LONG-TERM EXPOSURES TO

RTECS: 9999999ZZ

AS SILICOSIS. THESE EFTS ARE ASSOCD W/BRTHG

RTECS: 9999999ZZ

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:NO Ingestion:YES
Reports of Carcinogenicity:NTP:YES IARC:YES OSHA:NO
Health Hazards Acute and Chronic:ACUTE:INGEST:MAY BE HARMFUL.
EYE:CAUSES IRRIT. SKIN:MAY CAUSE SLIGHT IRRIT. INHAL:VAP & SPRAY
MIST MAY BE HARMFUL IF INHALED. SANDING & GRINDING DUSTS MAY BE
HARFMUL IF INHALED. VAP GENERATED AT ELEVA TED TEMPS IRRITATES
EYES, NOSE & THROAT. CHRONIC:AVOID LONG TERM & RPTD CONT. PROD
CONTAINS A FORM OF (SUPP DATA)
Explanation of Carcinogenicity:CRYSTALLINE SILICA: GROUP 2A(IARC),
GROUP 2 (NTP)
Effects of Overexposure:REDNESS, ITCHING, BURNING SENSATION AND VISUAL
DISTURBANCES MAY INDICATE EXCESSIVE EYE CONTACT. DRYNESS, ITCHING,
CRACKING, BURNING, REDNESS, AND SWELLING ARE CONDITIONS ASSOCIATED
WITH EXCESSIVE SKIN CONTACT.
Medical Cond Aggravated by Exposure:NOT APPLICABLE.

First Aid:INGEST:DO NOT INDUCE VOMIT. EYE:FLUSH IMMED W/PLENTY OF WATER
FOR AT LEAST 15 MIN. SKIN:FLUSH IMMED W/PLENTY OF WATER FOLLOWED BY
WASHING W/SOAP & WATER. INHAL:IF AFTD BY VAP/SPRAY MIST, REMOVE TO
FRE SH AIR. APPLY ARTF RESP & OTHER SUPPORTIVE MEASURES AS REQD.
OTHER:IF ANY OF THE FOLLOWING OCCUR DURING/FOLLOWING USE OF PROD,
CONT POIS CTL CTR, EMER ROOM/MD IMMED; HAVE MATL SAFETY DATA (ING
8)

Flash Point Method:PMCC
Extinguishing Media:USE NFPA CLASS B EXTING (CO*2/DRY CHEM/UNIVERSAL AQ
FILM FORMING FOAM) DESIGNED TO EXTING NFPA CLASS IIIB LIQ FIRES.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPRVD SCBA & FULL PROT EQUIP
.WATER SPRAY MAY BE INEFTIVE.WATER SPRAY MAY BE USED TO COOL CLSD
CNTNRS TO PVNT PRESS BUILD-UP &(SUPP DATA)
Unusual Fire/Explosion Hazard:KEEP CNTNRS TIGHLTY CLSD. ISOLATE FROM
HEAT/ELEC EQUIP/SPKS & OPEN FLAMES. CLSD CNTNRS MAY EXPLODE WHEN
EXPOS TO EXTREME HEAT. DO NOT APPLY ON HOT (SUPP DATA)

Spill Release Procedures:PROVIDE MAXIMUM VENT. ONLY PERS EQUIPPED
W/PROPER RESP & SKIN & EYE PROT SHOULD BE PERMITTED IN AREA. REMOVE
ALL SOURCES OF IGNIT. TAKE UP SPILLED MATL W/SAWDUST, VERMICULITE,
OR OTHER ABSORBENT MATER IAL AND PLACE INTO CONTAINERS FOR
DISPOSAL.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:DO NOT STORE ABOVE 120F. STORE LARGE
QUANTITIES IN BUILDING DESIGNED AND PROTECTED FOR STORAGE OF NFPA
CLASS IIIB LIQUIDS.
Other Precautions:IF THIS MATL IS PART OF A MULTIPLE COMPONENT COATING
SYS, READ MATL SAFETY DATA SHEET(S) FOR OTHER COMPONENT(S) BEFORE
BLENDING AS RESULTING MIX MAY HAVE HAZARDS OF ALL OF ITS PARTS.
CNTNRS SHOULD BE GROUNDED WHEN POURING. AVOID (ING 13)

Respiratory Protection:WHERE VENTILATION IS INADEQUATE, USE A SUITABLE
NIOSH/MSHA APPROVED RESPIRATOR.
Ventilation:PROVIDE GEN DILUTION/LOC EXHST VENT IN VOL & PATTERN TO
KEEP CONC OF INGS LISTED BELOW LOWEST SUGGESTED EXPOS (ING 10)
Protective Gloves:POLYVINYL ALCOHOL, NEOPRENE (ING 12)
Eye Protection:CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:WEAR PROTECTIVE CLOTHING, INCLUDING
IMPERMEABLE APRON.
Work Hygienic Practices:CLEAN OR DISCARD CONTAMINATED CLOTHING AND
SHOES.
Supplemental Safety and Health
FIRE FIGHT PROC:POSS AUTOIGNIT/EXPLO WHEN EXPOS TO EXTREME HEAT. IF
WATER IS USED, FOG NOZ ARE PREF. EXPLO HAZ:SURFS. TOX GASES MAY
FORM WHEN PROD IS CONTACTED BY FLAME/HOT SURFS. HAZ DECOMP
PROD:FUME S INCLUDING: CO, FORMALDEHYDE. HLTH HAZ:CRYSTALLINE
SILICA WHICH IARC ASSOCIATES W/AN INCREASED RISK OF CANCER (ING 5)

HCC:T6
Boiling Pt:B.P. Text:>212F,>100C
Vapor Pres:17.1
Vapor Density:HVR/AIR
Spec Gravity:1.12
Evaporation Rate & Reference:32 (BUOAC=100)
Solubility in Water:53.8%
Appearance and Odor:VISCOUS LIQUID WITH AN ODOR CHARACTERISTIC OF THE
SOLVENTS LISTED.
Percent Volatiles by Volume:63.60

Stability Indicator/Materials to Avoid:YES
AVOID CONTACT WITH STRONG ALKALIES, STRONG MINERAL ACIDS, OR STRONG
OXIDIZING AGENTS.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:MAY PRODUCE HAS DECOMP PRODS WHEN
HEATED. WELDING/BRAZING/FLAME-CUTTING ON SURFS COATED W/PROD MAY
PRODUCE (SUPP DATA)

Waste Disposal Methods:WASTE MATERIAL MUST BE DISPOSED OF I/A/W
FEDERAL, STATE, PROVINCIAL, AND LOCAL ENVIRONMENTAL CONTROL
REGULATIONS. EMPTY CONTAINERS SHOULD BE RECYCLED OR DISPOSED OF
THROUGH AN APPROVED WASTE MANAGEMEN T FACILITY.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.